Add A Pppoe Routed Wan Connection - ZyXEL Communications P-794H User Manual

Table 43 WAN Connection: IPoA Routed (continued)
LABEL
Use DHCP
WAN IP address
Enable NAT on
this interface
Apply

7.4.7 Add a PPPoE Routed WAN Connection

If you select PPPoE routed as the WAN service type in the Create Service
screen, the following setup screen is displayed.
Figure 60 WAN Connection: PPPoE Routed
The following table describes the labels in this screen.
Table 44 WAN Connection: PPPoE Routed
LABEL
Description
VPI
VCI
P-794H User's Guide
DESCRIPTION
Select if you want to use DHCP or enter the static IP address
according to the settings your ISP provides.
If you select Use DHCP, the ISP assigns you a different IP each time
you connect to the Internet. Select this if you want to get a dynamic
IP address from the ISP.
If your ISP provides you a static IP address, select this and enter the
IP address here.
Select this option to activate NAT on this interface.
Click this to save your changes.
DESCRIPTION
Enter a short description for this WAN connection.
The valid range for the VPI is 0 to 255. Enter the VPI assigned to you.
The valid range for the VCI is 32 to 65535 (0 to 31 is reserved for
local management of ATM traffic). Enter the VCI assigned to you.
Chapter 7 WAN Setup
99