Add An Ipoa Routed Wan Connection - ZyXEL Communications P-794H User Manual

Chapter 7 WAN Setup
Table 42 WAN Connection: PPPoA Bridged (continued)
LABEL
LCC header mode Select on if you want to enable LLC header so that the P-794H can
HDLC header
mode
No
authentication/
PAP/CHAP
User name
Password
Apply

7.4.6 Add an IPoA Routed WAN Connection

If you select IPoA routed as the WAN service type in the Create Service screen,
the following setup screen is displayed.
Figure 59 WAN Connection: IPoA Routed
The following table describes the labels in this screen.
Table 43 WAN Connection: IPoA Routed
LABEL
Description
VPI
VCI
98
DESCRIPTION
transmit and receive packets containing LLC headers. Select off if you
want to disable it.
Select on if you want to enable High Level Data Link Control (HDLC)
header so that the P-794H can transmit and receive packets
containing HDLC headers. Select off if you want to disable it.
Select the authentication protocol type provided by your ISP. You can
choose from No authentication, PAP, or CHAP.
The P-794H supports PAP (Password Authentication Protocol) and
CHAP (Challenge Handshake Authentication Protocol). CHAP is more
secure than PAP; however, PAP is readily available on more platforms.
Enter the user name exactly as your ISP assigned. If assigned a name
in the form user@domain where domain identifies a service name,
then enter both components exactly as given.
Enter the password associated with the user name above.
Click this to save your changes.
DESCRIPTION
Enter a short description for this WAN connection.
The valid range for the VPI is 0 to 255. Enter the VPI assigned to you.
The valid range for the VCI is 32 to 65535 (0 to 31 is reserved for
local management of ATM traffic). Enter the VCI assigned to you.
P-794H User's Guide