Table of Contents
Advertisement
Chapter 7 WAN Setup
Table 44 WAN Connection: PPPoE Routed (continued)
LABEL
PPPoE Auto
Connect
Discover IP
Subnet from IPCP
WAN IP address
Enable NAT on
this interface
LCC header mode Select on if you want to enable LLC header so that the P-794H can
HDLC header
mode
Authentication
Type
User name
Password
User Idle Timeout
Configure
7.5 Edit a WAN Connection
Click Edit next to an existing WAN connection to configure detailed settings. The
configuration screens vary according to the service mode of your connection.
100
DESCRIPTION
Select enable if you want the P-794H to establish a PPPoE connection
when starting up and to automatically re-establish it when
disconnected by the ISP.
Select enable if you want to get your IP subnet from the PPP Internet
Protocol Control Protocol (IPCP). If not, select disable.
If your ISP provides you a static IP address, select this and enter the
IP address here.
Select this option to activate NAT on this interface.
transmit and receive packets containing LLC headers. Select off if you
want to disable it.
Select on if you want to enable High Level Data Link Control (HDLC)
header so that the P-794H can transmit and receive packets
containing HDLC headers. Select off if you want to disable it.
The P-794H supports PAP (Password Authentication Protocol) and
CHAP (Challenge Handshake Authentication Protocol). CHAP is more
secure than PAP; however, PAP is readily available on more platforms.
Select the authentication protocol type provided by your ISP. You can
choose from:
•
auto: The P-794H accepts either CHAP or PAP when requested by
this remote node.
•
non: The P-794H does not accept any authentication protocol
type.
•
pap: The P-794H accepts PAP only.
•
chap: The P-794H accepts CHAP only.
Enter the user name exactly as your ISP assigned. If assigned a name
in the form user@domain where domain identifies a service name,
then enter both components exactly as given.
Enter the password associated with the user name above.
You can specify the time in minutes that elapses before the P-794H
automatically disconnects from the ISP. Enter 0 if you do not want the
connection to time out.
Click this to save your changes.
P-794H User's Guide
Advertisement
Table of Contents
