Table of Contents
Advertisement
Chapter 7 WAN Setup
Table 56 IPoA Routed: Edit IPoA (continued)
LABEL
Enabled
Change
Reset
7.5.5.3 Edit ATM Channel
Click the Edit Atm Channel tab to edit the ATM channel settings of the service.
Refer to
screen.
7.5.5.4 Edit IP Interface
Click the Edit IP Interface tab to edit the IP interface settings of the service.
Refer to
screen.
7.5.5.5 Edit TCP MSS Clamp
Click the Edit Tcp Mss Clamp tab to edit the TCP MSS Clamp settings of the
service. Refer to
in this screen.
7.5.5.6 Edit RIP Versions
Click the Edit Rip Versions tab to edit the RIP settings of the service. Refer to
Section 7.5.1.6 on page 106
7.5.5.7 Edit NAT
Click the Edit NAT tab to edit the NAT settings of the service. Refer to
7.5.1.7 on page 107
7.5.6 Edit a PPPoE Routed WAN Connection
Click Edit next to an existing PPPoE Routed WAN connection. Then click on the
tabs on top of the screen to configure detailed settings of the connection.
Figure 78 PPPoE Routed: Edit
120
DESCRIPTION
Select true to enable this WAN service. If not, select false.
Click this to save your changes.
Click this to restore your previously saved settings.
Section 7.5.1.3 on page 103
Section 7.5.1.4 on page 104
Section 7.5.1.5 on page 105
for detailed descriptions of the fields in this screen.
for detailed descriptions of the fields in this screen.
for detailed descriptions of the fields in this
for detailed descriptions of the fields in this
for detailed descriptions of the fields
Section
P-794H User's Guide
Advertisement
Table of Contents
