Chapter 1 Introduction
Table 1 LEDs (continued)
LED
CO
LAN 1~4
DSL 1~4
ALM
1.5 Turning the Power On/Off
You can turn the Device on/off by plugging/unplugging in to the right power
source.
Note: Pushing the Reset Switch down will turn off the
reset to default.
1.6 The Reset Switch
If you forget your password or cannot access the web configurator, you will need
to use the Reset switch at the back of the device to reload the factory-default
configuration file. This means that you will lose all configurations that you had
previously and the password will be reset to "1234".
1.6.1 Using the Reset Switch
Make sure the PWR LED is on.
1
24
COLOR
STATUS
DESCRIPTION
Green
On
The Device is in CO mode.
Off
The Device is in CPE mode.
Green
On
This port has a successful Ethernet connection.
Blinking
This port is sending/receiving data.
fast
Blinking
This port is not connected.
slow
Green
On
The DSL connection is up.
Blinking
The Device is initializing the DSL line.
fast
Blinking
There is no DSL connection.
slow
Red
On
The Device has malfunctioned or an error has
occurred.
Off
The Device is connected to the Internet successfully.
Device and the settings will be
P-794H User's Guide