Persistence Histogram - Teledyne LabMaster 10 Zi Series Getting Started Manual

LabMaster 10 Zi Oscilloscopes
6.
Touch #Values and enter the number of parameter values that will
be contained in the histogram.
7.
Touch #Bins and enter the number of bins that comprise the
histogram. This determines how many bars appear in the histogram.
8.
To let the oscilloscope position the histogram, check Enable Auto
Find, then touch the Find Center and Width button.
Viewing Thumbnail Histograms (Histicons)
Histicons are miniature histograms of measurement parameters that appear
on the measurement table. These thumbnail histograms let you see at a
glance the statistical distribution of each parameter.
1.
Choose Measure > Measure Setup from the menu bar to access the
Measure dialog.
2.
Select Show Table and choose to show My Measure (custom
parameters), Std Vertical measurements, or Std Horizontal
measurements.
3.
Turn On the parameters you wish to display.
4.
Select Show Histicons.
NOTE
: For measurements set up in My Measure, you can quickly display an
enlarged histogram of a thumbnail histogram by touching the Histicon you want to
enlarge. The enlarged histogram appears superimposed on the trace it describes.
This does not apply to

Persistence Histogram

You can create a histogram of a persistence display, specifying the
horizontal or vertical "slice" of the waveform to graph.
NOTE:
This math operation is different than the Histogram math operation and is
not affected by Center and Width settings made on any existing Histograms.
1.
Choose Math → Math Setup... from the menu bar to access the
Math dialog.
2.
Touch an open Fx button and select Phistogram from the pop-up
menu.
118
Std Vertical Std Horizontal
or measurements.
922561-00 Rev A