Table of Contents
Advertisement
RealPresence Collaboration Server (RMX) 1500/2000/4000 Deployment Guide for Maximum Security Environments
Installing the RMX 2000
For detailed instructions, precautions and requirements for installing the RMX 2000 refer to the
Polycom RMX 2000 Hardware Guide.
The following procedures have to be performed to install the RMX 2000 in your site:
•
•
•
•
Optional. Installing the RTM ISDN Card on the RMX 2000
If the ISDN option was purchased with your RMX, the ISDN card is shipped separately and
must be manually installed into the rear of the RMX 2000. It is recommended to install the
ISDN card before the RMX 2000 is placed in a rack.
Removing the blank cover from the rear of the RMX 2000
Use the following procedure to remove the blank cover:
1
2
3
Installing the RTM ISDN 2000 Card
A Software License is included with the ISDN card. This license must be registered as part of
the Product Registration and Product Activation process.
Mounting the Collaboration Server 2000 in a Rack
There are two methods for installing the Collaboration Server in a 19" rack:
•
1-12
Optional. Installing the RTM ISDN card on the RMX (Optional)
Installing the RMX in a rack or as a standalone
Connecting the RMX to the power source
Connecting the network (LAN and ISDN) cables to the RMX
Ensure that the power switch/circuit switch on the Collaboration Server is turned OFF
(O).
Unscrew the captive screws on the rear panel of the Collaboration Server that secure the
blank panel.
Use the metal ejector levers to pull the blank panel.
Using rack rail runners on the RMX 2000:
— Install the telescopic rail runners, as described in "Installing the Telescopic Rail
Runners on the Rack" on page 1-5.
— Mount the Collaboration Server 2000 on top of the rail runners.
Polycom, Inc.
Advertisement
Table of Contents
