Polycom Collaboration Server (RMX) 1500 Deployment Manual page 43

19 Click Next.
20 Define the following parameters:
Polycom, Inc.
Table 1-11 Fast Configuration Wizard – ISDN Service Settings
Field Description
Span Type Select the type of spans (ISDN/PSTN) lines, supplied by the service
provider, that are connected to the RMX. Each span can be defined as
a separate Network Service, or all the spans from the same carrier can
be defined as part of the same Network Service.
Select either:
•
•
Default: T1
Note: Only one Span Type (E1 or T1) is supported on the
Collaboration Server. If you define the first span as type E1 all other
spans that you may later define must also be of type E1.
Service Type PRI is the only supported service type. It is automatically selected.
The PRI Settings dialog box is displayed.
Table 1-12 Fast Configuration Wizard – PRI Settings
Field Description
Default Num Type Select the Default Num Type from the list.
The Num Type defines how the system handles the dialing digits. For
example, if you type eight dialing digits, the Num Type defines whether
this number is national or international.
If the PRI lines are connected to the RMX via a network switch, the
selection of the Num Type is used to route the call to a specific PRI line.
If you want the network to interpret the dialing digits for routing the call,
select Unknown.
Default: Unknown
Note: For E1 spans, this parameter is set by the system.
T1 (U.S. – 23 B channels + 1 D channel)
E1 (Europe – 30 B channels + 1 D channel)
Chapter 1-First Time Installation and Configuration
1-37