Table of Contents
Advertisement
Installing the RMX 4000
The following procedures have to be performed to install the RMX 4000 at your site:
•
•
•
•
Optional. Installing the RTM ISDN Card on the RMX 4000
If the ISDN option was purchased with your RMX, the ISDN card is shipped separately and
must be manually installed into the rear of the RMX 2000. It is recommended to install the
ISDN card before the RMX 2000 is placed in a rack.
Removing the RTM LAN Card or the blank cover from the rear of the RMX 4000
1
2
3
Installing the RTM ISDN 4000 Card
1
2
An RTM ISDN card must connect directly to an MPM+/MPMx card in the opposite facing front slot.
3
4
A Software License is included with the ISDN card. This license must be registered as part of
the Product Registration and Product Activation process.
Polycom, Inc.
Optional. Installing the RTM ISDN card on the RMX
Mounting the RMX in a rack
Connecting the RMX to the power source
Connecting the network (LAN and ISDN) cables to the RMX
Ensure that the power switch on the RealPresence Collaboration Server 1800 is turned OFF
(O).
Remove the RTM LAN or blank cover by unscrewing the captive screws that fasten the
card or the cover to the RMX. When removing a card, use the metal ejector levers to pull
the RTM LAN card out of its slot from the backplane.
Slide out the RTM LAN or RTM ISDN card.
On the RTM ISDN card move the ejector levers to their fully open position.
Slide the new RTM ISDN card into its slot.
Push the card into the slot until the ejector levers touch the front edge of the card cage.
Push the ejector levers to their fully closed position.
Tighten the captive screws on each side of the rear panel of the card, securing the RTM
ISDN card to the MCU.
Chapter 1-First Time Installation and Configuration
1-15
Advertisement
Table of Contents
