Table of Contents
Advertisement
RealPresence Collaboration Server (RMX) 1500/2000/4000 Deployment Guide for Maximum Security Environments
Procedure 2: Gather Network Equipment and Address
Information
IP Services
The IP addresses and network parameters which enable communication between the
Hardware
Collaboration Server, its management application and the conferencing devices are
Installation
contained in two IP services:
and
Setup
•
•
Gather Network
During the First Entry Configuration, the parameters of these two network services are
Equipment
and
modified to comply with your local network settings.
Address Info
Management Network
The Management Network enables communication between the Collaboration Server Control
First Entry
Unit and the Collaboration Server Web Client and is used to manage the Collaboration Server.
Configuration
The RMX is shipped with default IP addresses as listed in Table 2-1.
Signaling Network
The Signaling Network is used to configure and manage communications between the
Collaboration Server and conferencing devices.
IP Network Services Required Information
When installing an RMX unit, these default IP addresses must be modified to your local
network settings. It is therefore important to obtain the information needed to complete the
Local Network Settings section of the table from your network administrator before
powering up the RMX for the first time.
The network administrator should allocate four IP addresses in the local network for an
MCU with one MPM+ card and up to seven IP addresses for an MCU with up to four
MPM+ cards.
Table 1-2
Parameter
Control Unit IP Address
Control Unit Subnet Mask
Default Router IP Address
Shelf Management IP Address
Signaling Host IP address
1-20
Management Network (Control Unit)
Signaling Network (Conferencing Service)
Network Equipment and Address Information
Factory Default
192.168.1.254
255.255.255.0
192.168.1.1
192.168.1.252
–
Local Network
Settings
Polycom, Inc.
Advertisement
Table of Contents
