Table of Contents
Advertisement
RealPresence Collaboration Server (RMX) 2000 Hardware Guide
•
•
•
•
•
•
•
•
•
Installation Precautions
When handling electronic components, standard anti-static precautions must be observed:
•
Wear a grounding strap
•
Handle cards by their edges only and do not touch their components or connector pins
•
Keep components in anti-static bags, when not installed in the RMX 2000
The following precautions should be followed with regards to installation of the RMX 2000:
•
•
•
Installing the RealPresence Collaboration Server (RMX) 2000
The following procedures have to be performed to install the RMX 2000 in your site:
•
•
•
•
•
Unpacking the RealPresence Collaboration Server (RMX) 2000
To unpack and lift the RMX 2000:
1
2
1-6
Ensure that the leveling jacks on the bottom of the rack are fully extended to the floor
with the full weight of the rack resting on them.
In a single rack installation, stabilizers should be attached to the rack.
In multiple rack installations, the racks should be coupled together.
Always make sure the rack is stable before extending a component from the rack.
You should extend only one component at a time - extending two or more
simultaneously may cause the rack to become unstable.
Before you install the rails, determine the placement of each component in the rack.
Install the heaviest components on the bottom of the rack first, and then work up.
Allow the power supply units to cool before touching them.
Always keep the rack's trays and card's slots closed when not servicing, to maintain
proper cooling.
Use a regulating uninterruptable power supply (UPS) to protect the RMX 2000 from
power surges and voltage spikes, to keep your MCU operating in case of a power
failure.
Place the RMX 2000 on a hard, flat surface such as a desktop or mount it on 19" rack.
The airflow of the RMX 2000 is from right to left. Be sure that the areas in the left and
right side of the system are clear for proper ventilation.
Unpacking the RMX
Installing the RTM ISDN card on the RMX
Installing the RMX in a rack or as a standalone
Connecting the RMX 2000 to the power source
Connecting the network (LAN and ISDN) cables to the RMX
When you receive the RMX 2000 packing case, inspect the equipment for damage and
verify that the components match the packing slip.
Open the top cover of the packing case.
Boxes are placed on the top Stratocell® and contain the following:
— Installation Accessories. This kit contains the power cables, 1 ethernet cable, USB key
and documentation.
Polycom, Inc.
Advertisement
Table of Contents
