Installing The Realpresence Collaboration Server (Rmx) 2000; Optional. Installing The Rtm Isdn Card On The Rmx 2000 - Polycom 1500 Deployment Manual

Installing the RealPresence Collaboration Server (RMX) 2000

For detailed instructions, precautions and requirements for installing the RMX 2000 refer to the
RealPresence Collaboration Server (RMX) 2000 Hardware Guide.
The following procedures have to be performed to install the RMX 2000 in your site:
•
•
•
•

Optional. Installing the RTM ISDN Card on the RMX 2000

If the ISDN option was purchased with your RMX, the ISDN card is shipped separately and
must be manually installed into the rear of the RMX 2000. It is recommended to install the
ISDN card before the RMX 2000 is placed in a rack.
Removing the blank cover from the rear of the RMX 2000
Use the following procedure to remove the blank cover:
1
2
3
Installing the RTM ISDN 2000 Card
1
2
An RTM ISDN card must connect directly to an MPM/MPM+/MPMx card in the opposite facing front
slot.
Polycom, Inc.
Optional. Installing the RTM ISDN card on the RMX (Optional)
Installing the RMX in a rack or as a standalone
Connecting the RMX to the power source
Connecting the network (LAN and ISDN) cables to the RMX
Ensure that the power switch/circuit switch on the RMX is turned OFF (O).
Unscrew the captive screws on the rear panel of the RMX that secure the blank panel.
Use the metal ejector levers to pull the blank panel.
On the new RTM ISDN card move the ejector levers to their fully open position.
Slide in the RTM ISDN card in the RMX slot.
Chapter 1-First Time Installation and Configuration
1-13