Polycom Collaboration Server (RMX) 1500 Deployment Manual page 75

4
5
6
Polycom, Inc.
Select the Enable Whitelist check box.
All IP addresses in the list are displayed and the Add and Remove buttons become
active.
Modify the White List.
Both IPv4 and IPv6 addresses are supported and the system will only allow entry of the
type of IP addresses for which it is configured according to Table 1-21.
Table 1-21 IP Address Modes
IP Address Modes
RMX
IPv4
IPv6
IPv4 & IPv6
— If the system changes its IP addressing mode (e.g. from IPv4 only to both IPv4 &6)
while the White List is enabled, the White List is disabled and a message, White list
has been disabled please reconfigure, is displayed.
— IPv4 addresses can be added as a range by substituting the 3rd and 4th dotted
decimal numbers of the IP address with * characters, e.g. 11.10.*.*
Add IP addresses to the White List:
Workstation / Device
IPv4
IPv4 & IPv6
IPv6
IPv4 & IPv6
IPv4
IPv6
IPv4 & IPv6
Chapter 1-First Time Installation and Configuration
1-69