Polycom Collaboration Server (RMX) 1500 Deployment Manual page 35

2
3
Polycom, Inc.
Table 1-4 Signaling Network Service – IP Signaling
Field
Network Service
Name
Signaling Host IP
Address
Media Card 1-4
IP Addresses
Subnet Mask
Click the Next button.
Enter the required Routers information in the dialog box.
Table 1-5 Signaling Network Service – Routers
Field
Default Router Enter the IP address of the default router. The default router is used
IP Address whenever the defined static routers are not able to route packets to their
destination. The default router is also used when host access is
restricted to one default router.
Description
The name Default IP Service is assigned to the Signaling Network
Service by the Fast Configuration Wizard. This name can be
changed.
Note: This field is displayed in all IP Signaling dialog boxes and can
contain character sets that use Unicode encoding.
Enter the address to be used by IP endpoints when dialing into the
MCU.
Dial out calls from the Collaboration Server are initiated from this
address.
This address is used to register the Collaboration Server with a
Gatekeeper or a SIP Proxy server.
Enter the IP address(es) of the media card (s) (MPM+/MPMx 1 and
MPM+/MPMx 2-4 (if installed)) as provided by the network
administrator. Endpoints connect to conferences and transmit call
media (video, voice and content) via these addresses.
Enter the subnet mask of the MCU.
Default value: 255.255.255.0.
Chapter 1-First Time Installation and Configuration
Description
1-29