Configuring The Rmx - Serial Gateway Connection; Procedure 1: Initial Setup Of The Serial Gateway - Polycom Collaboration Server (RMX) 1500 Deployment Manual

RealPresence Collaboration Server (RMX) 1500/2000/4000 Deployment Guide for Maximum Security Environments

Configuring the RMX - Serial Gateway Connection

Configuring the connection between the Serial Gateway and the RMX consists of the
following procedures:
1
2

Procedure 1: Initial Setup of the Serial Gateway

The IP Addresses on the RMX that match those described in this procedure are described in
"Procedure 2: Configure a Network Service on the RMX for each of the Serial Gateways and Connect
the Serial Gateways to the RMX" on page 5-8.
1
2
5-4
Initial Setup of the Serial Gateway
Initial Setup must be completed for each of the Serial Gateways to be deployed.
For more information see "Setting Up Your Polycom RMX Serial Gateway S4GW" in the
RMX Serial Gateway S4GW System User Guide.
Configure a Network Service on the RMX for each of the Serial Gateways and
Connect the Serial Gateways to the RMX
Establish a serial connection between the Serial Gateway and the workstation. For more
information see "Setting Up Your Polycom RMX Serial Gateway S4GW" in the RMX Serial
Gateway S4GW System User Guide.
In the Administrator > Device > Settings > IP Connectivity > Peer List, enter the Signaling
Host IP Address (Signaling and Media). The RMX will use this IP address to connect to
the Serial Gateway's management interface.
Remove all other addresses from the Peer list. Each Serial Gateway uses the address of
the LAN port on the RTM-LAN card that is assigned to its Network Service.
Polycom, Inc.