3Com WX3000 Series Operation Manual page 573

Table 1-4 Default output rules for different output directions
Output Modules
direction allowed
default (all
Console
modules)
Monitor default (all
terminal modules)
default (all
Log host
modules)
default (all
Trap buffer
modules)
default (all
Log buffer
modules)
default (all
SNMP NMS
modules)
Enabling system information display on the console
After setting to output system information to the console, you need to enable the associated display
function to display the output information on the console.
Follow these steps to enable the system information display on the console:
To do...
Enable the debugging/log/trap
information terminal display
function
Enable debugging information
terminal display function
Enable log information terminal
display function
Enable trap information
terminal display function
Make sure that the debugging/log/trap information terminal display function is enabled (use the
terminal monitor command) before you enable the corresponding terminal display function by using
the terminal debugging, terminal logging, or terminal trapping command.
LOG
Enable
Severit Enabled/
d/disab
y disabled
led
Enable warning
Enabled
d s
Enable warning
Enabled
d s
Enable informati
Enabled
d onal
Disable informati
Enabled
d onal
Enable warning
Disabled
d s
Disable debuggi
Enabled
d ng
Use the command...
terminal monitor
terminal debugging
terminal logging
terminal trapping
1-9
TRAP
Enabled/
Severity
disabled
debuggin
Enabled
g
debuggin
Enabled
g
debuggin
Disabled
g
warnings Disabled
debuggin
Disabled
g
warnings Disabled
Remarks
Optional
Enabled by default.
Optional
Disabled by default.
Optional
Enabled by default.
Optional
Enabled by default.
DEBUG
Severity
debuggin
g
debuggin
g
debuggin
g
debuggin
g
debuggin
g
debuggin
g