3Com WX3000 Series Operation Manual page 39

1) Perform Telnet-related configuration on the switching engine operating as the Telnet server. For
details, refer to Telnet Configuration with Authentication Mode Being
with Authentication Mode Being
Being Scheme.
2) Telnet to the access control engine as the Telnet client.
3) Execute the following command on the access control engine operating as the Telnet client:
<device> telnet xxxx
Note that xxxx is the IP address or the host name of the access control engine operating as the Telnet
server. You can use the ip host to assign a host name to the access control engine.
4) After successful login, the CLI prompt (such as <device>) appears. If all the VTY user interfaces of
the switching engine are in use, you will fail to establish the connection and receive the message
that says "All user interfaces are used, please try later!".
5) After successfully Telnetting to the switching engine, you can configure the switching engine or
display the information about the switching engine by executing corresponding commands. You
can also type ? at any time for help. Refer to the subsequent chapters for the information about the
commands.
Password, and Telnet Configuration with Authentication Mode
3-14
None, Telnet Configuration