Configuring A Mac Address Entry - 3Com WX3000 Series Operation Manual

Configuring a MAC Address Entry

You can add, modify, or remove a MAC address entry, remove all MAC address entries concerning a
specific port, or remove specific type of MAC address entries (dynamic or static MAC address entries).
You can add a MAC address entry in either system view or Ethernet port view.
Adding a MAC address entry in system view
Follow these steps to add a MAC address entry in system view:
To do...
Enter system view
Add a MAC address entry
When you add a MAC address entry, the port specified by the interface argument must belong to
the VLAN specified by the vlan argument in the command. Otherwise, the entry will not be added.
If the VLAN specified by the vlan argument is a dynamic VLAN, after a static MAC address is
added, it will become a static VLAN.
Adding a MAC address entry in Ethernet port view
Follow these steps to add a MAC address entry in Ethernet port view:
To do...
Enter system view
Enter Ethernet port view
Add a MAC address entry
When you add a MAC address entry, the current port must belong to the VLAN specified by the
vlan argument in the command. Otherwise, the entry will not be added.
If the VLAN specified by the vlan argument is a dynamic VLAN, after a static MAC address is
added, it will become a static VLAN.
Use the command...
system-view
mac-address { static | dynamic |
blackhole } mac-address interface
interface-type interface-number vlan
vlan-id
Use the command...
system-view
interface interface-type interface-number
mac-address { static | dynamic |
blackhole } mac-address vlan vlan-id
1-5
Remarks
—
Required
Remarks
—
—
Required