3Com WX3000 Series Operation Manual page 77

Configuration procedure
# Create VLAN 100 and VLAN 200, and add GigabitEthernet 1/0/11 and GigabitEthernet 1/0/12 to
VLAN 100 and VLAN 200 respectively.
<device> system-view
[device] vlan 100
[device-vlan100] port GigabitEthernet 1/0/11
[device-vlan100] quit
[device] vlan 200
[device-vlan200] port GigabitEthernet 1/0/12
# Configure protocol templates for VLAN 200 and VLAN 100, matching AppleTalk protocol and IP
protocol respectively.
[device-vlan200] protocol-vlan at
[device-vlan200] quit
[device] vlan 100
[device-vlan100] protocol-vlan ip
# To ensure the normal operation of IP network, you need to configure a user-defined protocol template
for VLAN 100 to match the ARP protocol (assume Ethernet II encapsulation is adopted here).
[device-vlan100] protocol-vlan mode ethernetii etype 0806
# Display the created protocol-based VLANs and the protocol templates.
[device-vlan100] display protocol-vlan vlan all
VLAN ID: 100
VLAN Type: Protocol-based VLAN
Protocol Index
0
1
VLAN ID: 200
VLAN Type: Protocol-based VLAN
Protocol Index
0
# Configure GigabitEthernet 1/0/10 as a hybrid port, which removes the VLAN tag of the packets of
VLAN 100 and VLAN 200 before forwarding the packets.
[device-vlan100] quit
[device] interface GigabitEthernet 1/0/10
[device-GigabitEthernet1/0/10] port link-type hybrid
[device-GigabitEthernet1/0/10] port hybrid vlan 100 200 untagged
# Associate GigabitEthernet 1/0/10 with protocol template 0 and 1 of VLAN 100, and protocol template
0 of VLAN 200.
[device-GigabitEthernet1/0/10] port hybrid protocol-vlan vlan 100 0 to 1
[device-GigabitEthernet1/0/10] port hybrid protocol-vlan vlan 200 0
# Display the associations between GigabitEthernet 1/0/10 and the VLAN protocol templates to verify
your configuration.
[device-GigabitEthernet1/0/10] display protocol-vlan interface GigabitEthernet 1/0/10
Interface:GigabitEthernet1/0/10
Protocol Type
ip
ethernetii etype 0x0806
Protocol Type
at
2-8