Displaying Debugging Status; Displaying Operating Information About Modules In System - 3Com WX3000 Series Operation Manual

You can use the following commands to enable the two settings.
Follow these steps to enable debugging and terminal display for a specific module:
To do...
Enable system debugging for
specific module
Enable terminal display for
debugging
The output of debugging information affects the system operation. Disable all debugging after you finish
the system debugging.

Displaying Debugging Status

Follow these steps to display the current debugging status in the system:
To do...
Display all enabled debugging
on the current device

Displaying Operating Information about Modules in System

When the device is in trouble, you may need to view a lot of operating information to locate the problem.
Each functional module has its corresponding operating information display command(s). You can use
the command here to display the current operating information about the modules in the system for
troubleshooting your system.
Follow these steps to display the current operation information about the modules in the system:
To do...
Display the current operation
information about the modules
in the system.
Use the command...
debugging module-name
[ debugging-option ]
terminal debugging
Use the command...
display debugging [ unit
unit-id ] [ interface
interface-type
interface-number ]
[ module-name ]
Use the command...
display
diagnostic-information
2-3
Remarks
Required
Disabled for all modules by
default.
Required
Disabled by default.
Remarks
You can execute the display
command in any view.
Remarks
You can use this command in
any view.
You should execute this
command twice to find the
difference between the two
executing results, thus helping
locate the problem.