Configuring The Pd Compatibility Detection Function; Upgrading The Pse Processing Software Online - 3Com WX3000 Series Operation Manual

To do...
Set the PoE mode on the port
to signal

Configuring the PD Compatibility Detection Function

After the PD compatibility detection function is enabled, the device can detect the PDs that do not
conform to the 802.3af standard and supply power to them.
After the PoE feature is enabled, perform the following configuration to enable the PD compatibility
detection function.
Follow these steps to configure the PD compatibility detection function:
To do...
Enter system view
Enable the PD compatibility
detection function

Upgrading the PSE Processing Software Online

The online upgrading of PSE processing software can update the processing software or repair the
software if it is damaged. Before performing the following configuration, download the PSE processing
software to the flash of the device .
Follow these steps to upgrade PSE processing software online:
To do...
Enter system view
Upgrade the PSE processing
software online
Use the command...
poe mode signal
Use the command...
system-view
poe legacy enable
Use the command...
system-view
poe update { refresh |
full } filename
1-5
Remarks
Optional
signal by default.
Remarks
—
Required
Disabled by default.
Remarks
—
Required
The specified PSE processing
software is a file with the
extension .s19.