Tcp Test (Tcpprivate Test) On The Specified Ports - 3Com WX3000 Series Operation Manual

[device-hwping-administrator-snmp] test-enable
# Display test results
[device-hwping-administrator-snmp] display hwping results administrator snmp
HWPing entry(admin administrator, tag snmp) test result:
Destination ip address:10.2.2.2
Send operation times: 10
Min/Max/Average Round Trip Time: 9/11/10
Square-Sum of Round Trip Time: 983
Last complete test time: 2000-4-3 8:57:20.0
Extend result:
SD Maximal delay: 0
Packet lost in test: 0%
Disconnect operation number: 0
System busy operation number: 0
Operation sequence errors: 0
Other operation errors: 0
[device-hwping-administrator-snmp] display hwping history administrator snmp
HWPing entry(admin administrator, tag snmp) history record:
Index
1
2
3
4
5
6
7
8
9
10
For detailed output description, see the corresponding command manual.

TCP Test (Tcpprivate Test) on the Specified Ports

Network requirements
Both the HWPing client and the HWPing server are WX3000 series devices. Perform a HWPing
Tcpprivate test to test time required to establish a TCP connection between this end (Switch A) and the
specified destination end (Switch B), with the port number set to 8000.
Network diagram
Figure 1-8 Network diagram for the Tcpprivate test
10.1.1.1/8
Switch A
HWPing Client
Response Status
10 1
10 1
10 1
10 1
9 1
11 1
10 1
10 1
10 1
10 1
IP network
10.2.2.2/8
Receive response times: 10
DS Maximal delay: 0
Operation timeout number: 0
Connection fail number: 0
Drop operation number: 0
LastRC Time
0 2000-04-03 08:57:20.0
0 2000-04-03 08:57:20.0
0 2000-04-03 08:57:20.0
0 2000-04-03 08:57:19.9
0 2000-04-03 08:57:19.9
0 2000-04-03 08:57:19.9
0 2000-04-03 08:57:19.9
0 2000-04-03 08:57:19.9
0 2000-04-03 08:57:19.8
0 2000-04-03 08:57:19.8
Switch B
HWPing Server
1-27