Port Binding Configuration Example - 3Com WX3000 Series Operation Manual

Port Binding Configuration Example

Network requirements
As shown in Figure
1/0/1 on switch A, so as to prevent malicious users from using the IP address they steal from Host 1 to
access the network.
Figure 2-1 Network diagram for port binding configuration
Switch A
GE1/0/1
Configuration procedure
Configure switch A as follows:
# Enter system view.
<device> system-view
# Enter GigabitEthernet 1/0/1 port view.
[device] interface GigabitEthernet 1/0/1
# Bind the MAC address and the IP address of Host 1 to GigabitEthernet 1/0/1.
[device-GigabitEthernet1/0/1] am user-bind mac-addr 0001-0002-0003 ip-addr 10.12.1.1
2-1, it is required to bind the MAC and IP addresses of Host 1 to GigabitEthernet
Switch B
Host 1
MAC: 0001- 0002-0003
IP Address : 10.12.1.1
Host 2
2-2