3Com WX3000 Series Operation Manual page 624

To do...
Configure the destination port
Configure the source IP
address
Configure the source port
Configure the test type
Configure the number of
probes per test
Configure the automatic test
interval
Configure the probe timeout
time
Configure the maximum
number of history records that
can be saved
Configure the type of service
Start the test
Display test results
8) Configuring UDP test on HWPing client
Follow these steps to configure UDP test on HWPing client:
Use the command...
destination-port
port-number
source-ip ip-address
source-port port-number
test-type { tcpprivate |
tcppublic }
count times
frequency interval
timeout time
history-records number
tos value
test-enable
display hwping results
[ admin-name operation-tag ]
1-13
Remarks
Required in a Tcpprivate test
A Tcppublic test is a TCP
connection test on port 7. Use
the hwping-server
tcpconnect ip-address 7
command on the server to
configure the listening service
port; otherwise the test will fail.
No port number needs to be
configured on the client; any
destination port number
configured on the client will not
take effect.
By default, no destination port
number is configured.
Optional
By default, the source IP
address is not specified.
Optional
By default, no source port is
specified.
Required
By default, the test type is
ICMP.
Optional
By default, one probe is made
per time.
Optional
By default, the automatic test
interval is zero seconds,
indicating no automatic test will
be made.
Optional
By default, a probe times out in
three seconds.
Optional
By default, the maximum
number is 50.
Optional
By default, the service type is
zero.
Required
Required
The display command can be
executed in any view.