Collecting/Clearing Traffic Statistics - 3Com WX3000 Series Operation Manual

Configuration example
# Configure a device to adopt SP+SDWRR combination for queue scheduling, assigning queue 3,
queue 4, and queue 5 to WRR scheduling group 1, with the weigh of 20, 20 and 30; assigning queue 0,
queue 1, and queue 2 to WRR scheduling group 2, with the weight 20, 20, and 40; using SP for
scheduling queue 6 and queue 7. Display the configuration information after configuration.
Configuration procedure:
<device> system-view
[device] queue-scheduler wrr group1 3 20 4 20 5 30 group2 0 20 1 20 2 40
[device] display queue-scheduler
QID: scheduling-group
-----------------------------------
0 : wrr , group2
1 : wrr , group2
2 : wrr , group2
3 : wrr , group1
4 : wrr , group1
5 : wrr , group1
6 : sp
7 : sp

Collecting/Clearing Traffic Statistics

Refer to Flow-based Traffic Accounting
Configuration prerequisites
The ACL rules for traffic classification are defined. Refer to the ACL module of this manual for
information about defining ACL rules.
Configuration procedure
You can collect traffic statistics or clear traffic statistics on all the packets matching specific ACL rules, or
on packets that match specific ACL rules and are of a VLAN, of a port group, or pass a port.
Follow these steps to collect traffic statistics on all the packets matching specific ACL rules:
To do...
Enter system view
Collect the statistics on the
packets matching specific ACL
rules
Clear the statistics on the packets
matching specific ACL rules
Follow these steps to collect traffic statistics on packets that are of a VLAN and match specific ACL
rules:
To do...
Enter system view
weight
20
20
40
20
20
30
0
0
for information about traffic accounting.
Use the command...
system-view
traffic-statistic inbound acl-rule
reset traffic-statistic inbound
acl-rule
Use the command...
system-view
1-27
Remarks
—
Required
Optional
Remarks
—