3Com WX3000 Series Operation Manual page 385

Follow these steps to redirect packets that are of a VLAN and match specific ACL rules:
To do...
Enter system view
Configure traffic redirecting
Follow these steps to redirect packets that are of a port group and match specific ACL rules:
To do...
Enter system view
Enter port group view
Configure traffic redirecting
Follow these steps to redirect packets passing a port and matching specific ACL rules:
To do...
Enter system view
Enter Ethernet port view
Configure traffic redirecting
If the traffic is redirected to a Combo port in down state, the system automatically redirects the traffic to
the port corresponding to the Combo port in up state. Refer to the Port Basic Configuration module of
this manual for information about Combo ports.
As the priority of traffic classification rules is higher than that of the default rules used for processing
protocol packets, redirecting all the packets or packets of a VLAN may affect device management that
is implemented through Telnet and so on.
Configuration example
GigabitEthernet 1/0/1 belongs to VLAN 2 and is connected to the 10.1.1.0/24 network segment.
Redirect all the packets from the 10.1.1.0/24 network segment to GigabitEthernet 1/0/7.
1) Method I
<device> system-view
[device] acl number 2000
[device-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255
Use the command...
system-view
traffic-redirect vlan vlan-id inbound acl-rule
interface interface-type interface-number
Use the command...
system-view
port-group group-id
traffic-redirect inbound acl-rule interface
interface-type interface-number
Use the command...
system-view
interface interface-type interface-number
traffic-redirect inbound acl-rule interface
interface-type interface-number
1-24
Remarks
—
Required
Remarks
—
—
Required
Remarks
—
—
Required