Creating An Isp Domain And Configuring Its Attributes - 3Com WX3000 Series Operation Manual

AAA
configuration

Creating an ISP Domain and Configuring Its Attributes

Follow these steps to create an ISP domain and configure its attributes:
To do...
Enter system view
Configure the form of the
delimiter between the user
name and the ISP domain
name
Create an ISP domain or set an
ISP domain as the default ISP
domain
Set the status of the ISP
domain
Set the maximum number of
access users that the ISP
domain can accommodate
Set the idle-cut function
Task
Creating an ISP Domain and Configuring
Its Attributes
Configuring separate AAA schemes
Configuring an AAA Scheme for an ISP
Domain
Configuring Dynamic VLAN Assignment
Configuring the Attributes of a Local
User
Cutting Down User Connections Forcibly
system-view
domain delimiter { at | dot }
domain { isp-name | default
{ disable | enable isp-name } }
state { active | block }
access-limit { disable | enable
max-user-number }
idle-cut { disable | enable
minute flow }
Required
Required
Required
Optional
Optional
Optional
Use the command...
2-2
Remarks
With separate AAA schemes, you
can specify authentication,
authorization and
schemes respectively.
You need to configure RADIUS or
HWATACACS before
RADIUS or
authentication.
Remarks
—
Optional
By default, the delimiter
between the user name and the
ISP domain name is "@".
Required
If no ISP domain is set as the
default ISP domain, the ISP
domain "system" is used as the
default ISP domain.
Optional
By default, an ISP domain is in
the active state, that is, all the
users in the domain are allowed
to request network service.
Optional
By default, there is no limit on
the number of access users
that the ISP domain can
accommodate.
Optional
By default, the idle-cut function
is disabled.
accounting
performing
HWTACACS