Displaying And Maintaining Hwping; Hwping Configuration Example; Icmp Test - 3Com WX3000 Series Operation Manual

Displaying and Maintaining HWPing

To do...
Display test history
Display the results of the latest
test

HWPing Configuration Example

ICMP Test

Network requirements
As shown in Figure
and Switch B uses ICMP to test the round trip time (RTT) for packets generated by the HWPing client to
travel to and back from the destination.
Figure 1-2 Network diagram for the ICMP test
10.1.1.1/8
Switch A
HWPing Client
Configuration procedure
Configure HWPing Client (Switch A):
# Enable HWPing client.
<device> system-view
[device] hwping-agent enable
# Create a HWPing test group, setting the administrator name to "administrator" and test tag to "ICMP".
[device] hwping administrator icmp
# Configure the test type as icmp.
[device-hwping-administrator-icmp] test-type icmp
# Configure the destination IP address as 10.2.2.2.
[device-hwping-administrator-icmp] destination-ip 10.2.2.2
# Configure to make 10 probes per test.
[device-hwping-administrator-icmp] count 10
# Set the probe timeout time to 5 seconds.
[device-hwping-administrator-icmp] timeout 5
# Start the test.
[device-hwping-administrator-icmp] test-enable
# Set the maximum number of history records that can be saved to 5.
[device-hwping-administrator-icmp] history-records 5
display hwping history
[ administrator-name operation-tag ]
display hwping results
[ administrator-name operation-tag ]
1-2, Switch A serves as the HWPing client. A HWPing ICMP test between Switch A
IP network
10.2.2.2/8
Use the command...
Switch B
1-17
Remarks
Available in any view