Setting To Output System Information To The Snmp Nms - 3Com WX3000 Series Operation Manual

To do...
Enable information output to
the log buffer
Configure the output rules of
system information
Set the format of time stamp in
the output information

Setting to Output System Information to the SNMP NMS

Follow these steps to set to output system information to the SNMP NMS:
To do...
Enter system view
Enable the information center
Enable information output to
the SNMP NMS
Configure the output rules of
system information
Set the format of time stamp in
the output information
To send information to a remote SNMP NMS properly, related configurations are required on both the
device and the SNMP NMS.
Use the command...
info-center logbuffer
[ channel { channel-number |
channel-name } | size
buffersize ]*
info-center source
{ modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity | state
state } ]*
info-center timestamp { log |
trap | debugging } { boot |
date | none }
Use the command...
system-view
info-center enable
info-center snmp channel
{ channel-number |
channel-name }
info-center source
{ modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity | state
state } ]*
info-center timestamp { log |
trap | debugging } { boot |
date | none }
1-13
Remarks
Optional
By default, the device uses
information channel 4 to output
log information to the log buffer,
which can holds up to 512
items by default.
Optional
Refer to Table 1-4 for the
default output rules of system
information.
Optional
By default, the time stamp
format of the output log
information is date.
Remarks
—
Optional
Enabled by default.
Optional
By default, the device outputs
trap information to SNMP
through channel 5.
Optional
Refer to Table 1-4 for the
default output rules of system
information.
Optional
By default, the time stamp
format of the information output
to the SNMP NMS is date.