3Com WX3000 Series Operation Manual page 105

Unified switches switching engine
Table of Contents

Advertisement

[SwitchA-GigabitEthernet1/0/3] port trunk permit vlan all
# Enable GVRP on GigabitEthernet 1/0/3.
[SwitchA-GigabitEthernet1/0/3] gvrp
[SwitchA-GigabitEthernet1/0/3] quit
2)
Configure Switch B
# The configuration procedure of Switch B is similar to that of Switch A and is thus omitted.
3)
Configure Switch C
# Enable GVRP on Switch C, which is similar to that of Switch A and is thus omitted.
# Create VLAN 5.
[SwitchC] vlan 5
[SwitchC-vlan5] quit
4)
Configure Switch D
# Enable GVRP on Switch D, which is similar to that of Switch A and is thus omitted.
# Create VLAN 8.
[SwitchD] vlan 8
[SwitchD-vlan8] quit
5)
Configure Switch E
# Enable GVRP on Switch E, which is similar to that of Switch A and is thus omitted.
# Create VLAN 5 and VLAN 7.
[SwitchE] vlan 5
[SwitchE-vlan5] quit
[SwitchE] vlan 7
[SwitchE-vlan7] quit
6)
Display the VLAN information dynamically registered on Switch A, Switch B, and Switch E.
# Display the VLAN information dynamically registered on Switch A.
[SwitchA] display vlan dynamic
Total 3 dynamic VLAN exist(s).
The following dynamic VLANs exist:
5, 7, 8,
# Display the VLAN information dynamically registered on Switch B.
[SwitchB] display vlan dynamic
Total 3 dynamic VLAN exist(s).
The following dynamic VLANs exist:
5, 7, 8,
# Display the VLAN information dynamically registered on Switch E.
[SwitchE] display vlan dynamic
Total 1 dynamic VLAN exist(s).
The following dynamic VLANs exist:
8
7)
Configure GigabitEthernet 1/0/1 on Switch E to operate in fixed GVRP registration mode and
display the VLAN information dynamically registered on Switch A, Switch B, and Switch E.
# Configure GigabitEthernet 1/0/1 on Switch E to operate in fixed GVRP registration mode.
[SwitchE] interface GigabitEthernet 1/0/1
1-8

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wx3024Wx3010Wx3008

Table of Contents