3Com WX3000 Series Operation Manual page 296

To do...
In system
view
Enable MAC
authentication for
the specified
In interface
port(s) or the
view
current port
Set the username mac-authentication authmode
in MAC address usernameasmacaddress [ usernameformat
mode for MAC { with-hyphen | without-hyphen } { lowercase |
authentication uppercase } | fixedpassword password ]
Set the
username in
fixed mode
for MAC
Set the username
authenticatio
in fixed mode for
n
MAC
authentication
Configure the
username
Configure the
password
Specify an ISP
domain for MAC
mac-authentication domain isp-name
authentication
Configure the MAC mac-authentication timer { offline-detect
authentication offline-detect-value | quiet quiet-value |
timers server-timeout server-timeout-value }
If MAC authentication is enabled on a port, you cannot configure the maximum number of dynamic
MAC address entries for that port (through the mac-address max-mac-count command), and
vice versa.
If MAC authentication is enabled on a port, you cannot configure port security (through the
port-security enable command) on that port, and vice versa.
You can configure MAC authentication on a port before enabling it globally. However, the
configuration will not take effect unless MAC authentication is enabled globally.
Use the command...
mac-authentication interface
interface-list
interface interface-type
interface-number
mac-authentication
quit
mac-authentication authmode
usernamefixed
mac-authentication authusername
username
mac-authentication authpassword
password
1-3
Remarks
Use either method
Disabled by default
Optional
By default, the MAC
address of a user is
used as the
username.
Optional
By default, the
username is "mac"
and no password is
configured.
Required
The default ISP
domain (default
domain) is used by
default.
Optional
The default timeout
values are as
follows:
300 seconds for
offline detect timer;
60 seconds for quiet
timer; and
100 seconds for
server timeout timer