Measure:vdelta - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

7
Obsolete and Discontinued Commands

:MEASure:VDELta

Query Syntax
:MEASure:VDELta?
The :MEASure:VDELta? query returns the voltage difference between
vertical marker 1 (Y1 cursor) and vertical marker 2 (Y2 cursor). No
measurement is made when the :MEASure:VDELta? query is received by
the oscilloscope. The delta value that is returned is the current value. This
is the same value as the front- panel cursors delta Y value.
VDELta = value at marker 2 - value at marker 1
The :MEASure:VDELta command is an obsolete command provided for compatibility to
N O T E
previous oscilloscopes. Use the :MARKer:YDELta command (see
Return Format
<value><NL>
<value> ::= delta V value in NR1 format
See Also
•
•
•
•
•
•
•
534
(see page 586)
"Introduction to :MARKer Commands"
"Introduction to :MEASure Commands"
":MARKer:Y1Position"
":MARKer:Y2Position"
":MARKer:YDELta" on page 251
":MEASure:TDELta" on page 525
":MEASure:TSTArt" on page 529
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
on page 242
on page 257
on page 249
on page 250
page 251) instead.