I Skip Channel Setting - Icom IC-2820H Instruction Manual

I Skip channel setting

The memory skip function speeds up scanning by checking
only those memory channels not set as skip channels. Set
skip channels as follows.
Skip appears
q Select a memory channel in the desired MAIN band:
➥ Push the desired MAIN band's [M/CALL•MW] to select
memory mode.
➥ Rotate the same band's [DIAL] to select the desired
channel to be a skip channel.
w Push [F F •
] to display the function guide.
e Push [TONE•DTMF] to select the skip condition from "≈,"
"P≈" or "OFF" for the selected channel.
≈
• " "(SKIP) : The channel is skipped during memory or bank
scan.
P≈
• " "(PSKIP) : The channel is skipped during memory/bank
scan and the programmed scan.
__
• " "(OFF) : The channel is scanned during any scan.
r Push [F F •
] to exit the function guide.
SCAN OPERATION
z Select a memory channel.
➥ Select memory mode by pushing [MR/CALL].
SET
B
➥ Push [Y] or [Z] to select the desired channel
to be a skip channel.
• Direct memory channel selection is also available.
x Push [
B(D-OFF)] to enter set mode.
SET
c Push [
B(D-OFF)] or [
SET
times until "CHS" appears as shown at left.
v Push [Y] or [Z] to set or cancel the skip setting.
• See item r at left for skip indicator details.
b Push [
A(MW)] to exit set mode.
CLR
7
1
2
3
4
5
6
C(T-OFF)] several
ENT
7
8
9
10
11
12
13
14
15
16
17
18
19
54