Skip Channel Setting - Icom ID-800H Instruction Manual

■ Skip channel setting

The memory skip function speeds up scanning by checking
only those memory channels not set as skip channels. Set
skip channels as follows.
The display shows that mem-
ory channel 1 is set as a skip
channel.
q Select a memory channel:
➥ Push [M/CALL•PRIO] to select memory mode.
➥ Rotate [DIAL] to select the desired channel to be a skip
channel.
w Push [SET•LOCK] to enter set mode.
• Rotate [DIAL] to select "SET," if necessary.
e Push [SET•LOCK] or [S.MW•MW] several times until
"CHS" appears as shown above.
r Rotate [DIAL] to turn the skip function ON or OFF for the
selected channel.
• "~" appears : The channel is skipped during scan.
(CHS-ON)
• "P ~" appears : The channel is skipped during scan and the
programmed frequency is skipped during VFO scan, such as
programmed scan.
(CHS-ON)
• "~" disappears : The channel is scanned during scan.
(CHS-OF)
t Push [MONI•DTMF] to exit set mode.
[
SET
B
SCAN OPERATION
z Select a memory channel.
➥ Select memory mode by pushing [MR/CALL].
➥ Push [Y] or [Z] to select the desired channel
to be a skip channel.
• Direct memory channel selection is also available.
x Push [
B(D-OFF)] to enter set mode.
SET
• Push [Y] or [Z] to select "SET," if necessary.
c Push [
B(D-OFF)] or [
SET
times until "CHS" appears as shown at left.
v Push [Y] or [Z] to set or cancel the skip setting.
• See item r at left for skip indicator details.
b Push [
A(MW)] to exit set mode.
CLR
7
C(T-OFF)] several
ENT
7
44