Call Channel Programming; Adjusting The Volume Level - Icom IC-M36 Instruction Manual

■ Call channel programming

The Call channel is used to access Channel 9 (default).
However, you can enter the Call channel with your most
often-used channels in each channel group for quick recall.
q Hold down [CH/WX U/I/C] for 1 second several times to
select the channel group (USA, International or Canada)
to be programmed. (p. 9)
w Hold down [16 9] for 1 second to select the Call channel
of the selected channel group.
• "CALL" and Call channel number appear.
e Hold down [16 9] again for 3 sec-
onds. (until a long beep changes
to 2 short beeps) to enter the Call
channel entering mode.
• Channel number starts blinking.
r Push [Y]/[Z] to select the chan-
nel.
t Push [16 9] to program the dis-
played channel as the Call chan-
nel.
• The channel number stops blinking.

■ Adjusting the volume level

The volume level can be adjusted with [VOL/SQL MONI]
and [Y]/[Z].
q Push [VOL/SQL MONI] once to enter the volume adjust-
ment mode, then adjust the volume level with [Y]/[Z].
• "VOL" indicator starts blinking.
• The transceiver has 31 volume levels and OFF.
• With no key operation is performed for 5 seconds, the trans-
ceiver returns to the normal condition.
w Push [VOL/SQL MONI] twice to exit the volume adjust-
ment mode.
Blinks while adjusting the volume level.
BASIC OPERATION
Indicates the
volume level.
4
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
11