I Programming A Call Channel - Icom IC-V8000 Instruction Manual

I Programming a call channel

In addition to an operating frequency, duplex information, sub-
audible to information (ton encoder or tone squelch ON/OFF
and its frequency) and an alphanumeric channel names can
be programmed into the call channel.
q Set the desired frequency in VFO mode.
➥ Push [V/MHz(SCAN)] to select VFO mode.
➥ Set the frequency using the tuning dial.
➥ Set other data as desired.
w Push [MW(S.MW)] momentarily.
e Rotate the tuning dial to select the call channel
• "M" indicator and large "C" blink.
[EXAMPLE]: Programming 145.120 MHz into the call channel via the microphone.
Push to select VFO mode.
Push until large "C" appears.
r Push [MW(S.MW)] for 1 sec. to program.
• 3 beeps sound and return to VFO mode automatically.
MR/CALL
[Y]/[Z]
Set the frequency.
Push , then push for 1 sec.
CALL CHANNEL OPERATION
z Set the desired frequency in VFO mode.
➥ Push [VFO/LOCK] to select VFO mode.
➥ Set the frequency.
➥ Set other data as desired.
MW
x Push [FUNC], then [
c Select the call channel via [Y] or [Z] .
v Push [FUNC] then [
program.
• 3 beeps sound and the return to VFO mode auto-
matically.
Push , then
➠
"
"
Beep
"
Beep
"
Beep
"
7
A(MW)] momentarily.
CLR
A(MW)] for 1 sec. to
CLR
.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
36