I Call Channel Programming; I Channel Names; I Microphone Lock Function - Icom IC-M302 Instruction Manual

3
BASIC OPERATION

I Call channel programming

The call channel is used to select Channel 9, however, you
can program your most often-used channels in each channel
group for quick recall.
q Push both [Y] and [Z] one or more times to select the de-
sired channel group (U.S.A., International, Canada) to be
programmed.
w Push [16•
] for 1 sec. to se-
9
lect the call channel of the
selected channel group.
• "CALL" and call channel
number appear.
e Push [16•
] again for 3
9
sec. (until a long beep
changes to 2 short beeps)
to enter call channel pro-
gramming condition.
• Channel number
blinking.
r Push [Y]/[Z] to select the
desired channel.
t Push [16•
] to program
9
the displayed channel as
the call channel.
• Push [CH/WX
•DUAL
cel.
• The channel number stops
blinking.
8
starts
] to can-

I Channel names

Memory channels can be tagged with alphanumeric names
of up to 10 characters each.
Capital letters, small letters (except f, j, p, s, y, x, z), 0 to 9,
some symbols (= ✱ + – . /) and space can be used.
q Select the desired memory channel.
• Cancel dual watch, tri-watch or scan in advance.
w While pushing [CH/WX•
], push [16• ] to edit
DUAL 9
the channel name.
• A cursor and the first char-
acter starts blinking alter-
nately.
e Select the desired character by pushing [Y]/[Z].
r Push [CH/WX•
] or [16•
DUAL
t Repeat steps e and r to input all characters.
y Push [DSC•
] to set the channel name.
POS
u Repeat steps q to y to program other memory channel
names, if desired.

I Microphone lock function

The microphone lock function electrically locks the [Y]/[Z]
and [HI/LO] switches on the supplied microphone. This pre-
vents accidental channel changes and function access.
➥ While pushing [HI/LO] on the microphone, turn power ON
to toggle the lock function ON and OFF.
] for cursor movement.
9