Example; Enabling Digi64S2 - 3Com NETBuilder SI Using Manual

Enabling Digi64S2

1 Set the LineType parameter to Digi64S2 by entering:
2 Toggle the respective paths by entering:
Configuring ISDN on the WAN Port (43x, 44x, 53x, and 54x)
Permissive. The answering device must be capable of generating the
2.1 KHz tone needed to disable any echo cancellers on the line. Consult
with the owner of the destination equipment to see whether it has this
capability.
To configure this feature, you must define the DialNoList entry with a type
of BriV, by using:
ADD !<port> -POrt DialNoList "<phone number>" Type=BriV
The Baud specifier in the ADD command, although not disallowed, is
ignored if present. Data sent over the B channel will only be sent at 56
Kbps.

Example

To place a data over voice call on port 2 to an ISP with the phone number
453-4444, enter:
ADD !2 -POrt DialNoList "4534444" Type=BriV
There are two types of ISDN leased lines in Germany: Digi64S and
Digi64S2. Digi64S can run only on the B1 channel, but Digi64S2 can run
on the B1 and B2 channels.
To enable the Digi64S2 feature, follow these steps:
SETDefault !2.1 -PAth LineType = Digi64S2 (abbreviated d64s2)
SETDefault !2.2 -PAth LineType = Digi64S2
SETDefault !2.1 -PAth cont=e
SETDefault !2.2 -PAth cont=e
Path 2.1 is mapped to the B1 channel and path 2.2 is mapped to the B2
channel. This mapping is not interchangeable.
If one of the paths is set to Digi64S2, the path in the same connector line
is also set to Digi64S2. Mixtures of line types within a single connector
are not supported.
73