Installing A Power Supply; Verifying Proper Operation; Removing A Power Supply - HP StorageWorks 6100 - Enterprise Virtual Array User Manual
Hp storageworks 4x00/6x00/8x00 enterprise virtual array user guide (5697-8037, april 2009)
Hide thumbs
Also See for StorageWorks 6100 - Enterprise Virtual Array:
- User manual (462 pages) ,
- User manual (362 pages) ,
- User manual (186 pages)
Table of Contents
Advertisement
Figure 60 Removing a power supply
Installing a power supply
1.
Lift up on the module latch (1,
fully seated.
2.
Connect the power cord to the power supply and engage the cord lock.
Figure 61 Installing a power supply
Verifying proper operation
After replacing the power supply or blower, check the following to verify that the component is
operating properly:
NOTE:
It may take up to 10 minutes for the component to display good status.
126
Customer replaceable units
Figure
61) and slide the power supply into the enclosure until it is
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the StorageWorks 6100 - Enterprise Virtual Array and is the answer not in the manual?
Questions and answers