5 Customer replaceable units
This chapter describes customer replaceable units. Information about initial enclosure installation, ESD
protection, and common replacement procedures is also included.
Customer self repair (CSR)
Hardware component CSR support
Using WEBES, ISEE or other diagnostic tools, a support specialist will work with you to diagnose and
assess whether a replacement component is required to address a system problem. The specialist will
also help you determine whether you can perform the replacement.
Parts only warranty service
Your HP Limited Warranty may include a parts only warranty service. Under the terms of parts only
warranty service, HP will provide replacement parts free of charge.
For parts only warranty service, CSR part replacement is mandatory. If you request HP to replace
these parts, you will be charged for travel and labor costs.
Best practices for replacing hardware components
The following information will help you replace the hardware components on your storage system
successfully.
CAUTION:
Removing a component significantly changes the air flow within the enclosure. All components must
be installed for the enclosure to cool properly. If a component fails, leave it in place in the enclosure
until a new component is available to install.
Component replacement videos
To assist you in replacing the components, videos have been produced of the procedures. You can
view the videos at the following website.
http://www.hp.com/go/sml
Verifying component failure
•
Consult HP technical support to verify that the hardware component has failed and that you are
authorized to replace it yourself.
identifies which hardware components are customer replaceable.
HP StorageWorks 4x00/6x00/8x00 Enterprise Virtual Array user guide
101
Need help?
Do you have a question about the StorageWorks 6100 - Enterprise Virtual Array and is the answer not in the manual?
Questions and answers