Removing A Blower; Installing A Blower - HP StorageWorks 6100 - Enterprise Virtual Array User Manual

Removing a blower

It is not necessary to remove the power supply to replace a failed blower.
WARNING!
The blower motor does not stop immediately when the blower is removed. Keep your fingers away
from the blower blades until the motor stops.
While pushing in on the two red wine-colored mounting tabs (1,
from the power supply.
Figure 58 Removing a blower

Installing a blower

CAUTION:
Pressing on the center section of the blower can damage the blades or the housing. Only press on
the outer edge of the blower when installing it.
1.
Align the blower guide post (2,
connector (1).
2. Slide the blower onto the power supply (4) until the mounting tabs (3) snap into place.
124 Customer replaceable units
Figure 59) with the mounting hole next to the power supply
Figure 58), pull the blower (2) away