Adding A Disk Drive; Removing The Drive Blank; Sequential Building Of Vertical Disk Groups - HP StorageWorks 6100 - Enterprise Virtual Array User Manual

NOTE:
Standard and FATA disk drives must be in separate disk groups. Disk drives of different capacities
and spindle speeds can be included in the same disk group, but you may want to consider separating
them into separate disk groups.
1
Figure 7 Sequential building of vertical disk groups
1. Disks installed in first group
2. Disks installed in second group

Adding a disk drive

This section describes the procedure for adding a Fibre Channel disk drive.

Removing the drive blank

1. Grasp the drive blank by the two mounting tabs (see
2. Lift up on the lower mounting tab and pull the blank out of the enclosure.
2
26428a
HP StorageWorks 4x00/6x00/8x00 Enterprise Virtual Array user guide
Figure 8).
47