Class A Equipment; Class B Equipment; Declaration Of Conformity For Products Marked With The Fcc Logo, United States Only - HP StorageWorks 6100 - Enterprise Virtual Array User Manual

NOTE:
Additional information on the need to interconnect the device with shielded (data) cables or the need
for special devices, such as ferrite beads on cables, is required if such means of interference suppression
was used in the qualification test for the device. This information will vary from device to device and
needs to be obtained from the HP EMC group.

Class A equipment

This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. Operation
of this equipment in a residential area is likely to cause harmful interference, in which case the user
will be required to correct the interference at personal expense.

Class B equipment

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit that is different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio or television technician for help.

Declaration of conformity for products marked with the FCC logo, United States only

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
For questions regarding your product, see http://thenew.hp.com.
For questions regarding this FCC declaration, contact:
• Hewlett-Packard Company Product Regulations Manager, 3000 Hanover St., Palo Alto, CA 94304
• Or call 1-650-857-1501
To identify this product, see the part, series, or model number found on the product.
130 Regulatory notices and specifications