HP StorageWorks 6100 - Enterprise Virtual Array User Manual page 74

• Element number The second display is a two-digit decimal number that defines the specific element
reporting the problem. The format for this display is en. with a period after the second character.
• Error code The third display is a two-digit decimal number that defines the specific error code.
The format for this display is ec without any periods.
For detailed information about each condition report, including recommended corrective actions, see
145.
Navigating the error condition display
When an error condition occurs, the alphanumeric display changes to Er and the error menu is active.
The buttons are used to display the error condition values.
Perform the following procedure to display error conditions.
displaying error conditions.
1. With Er in the display, press and hold the top push-button until the first element type is displayed.
The most severe error in the queue will be displayed.
2.
Release the top push-button when the element type is displayed. The element type has both
decimal points lit.
3. Press and release the top push-button to display the element number. This display has only the
right decimal point lit.
4. Press and release the top push-button again to display the error code. This display has no decimal
points lit. Repeated press/release operations will cycle through these three values.
5. Press and hold the top push-button from any of the three display states to move to the element
type for the next error condition in the queue.
6.
Use the top push-button to display the values for the error condition.
7.
When all error conditions have been displayed, press and release the bottom pushbutton to return
to the Er display.
74 Enterprise Virtual Array hardware components
Figure 21 illustrates the sequence for