Raising A Leveler Foot - HP StorageWorks 6100 - Enterprise Virtual Array User Manual

If the feet are not fully raised, complete the following procedure:
1.
Raise one foot by turning the leveler foot hex nut counterclockwise until the weight of the rack is
fully on the caster (see
2.
Repeat Step 1 for the other feet.
1
2
Figure 36 Raising a leveler foot
1. Hex nut
3. Carefully move the rack to the installation area and position it to provide the necessary service
areas (see Figure 35).
To stabilize the rack when it is in the final installation location:
1. Use a wrench to lower the foot by turning the leveler foot hex nut clockwise until the caster does
not touch the floor. Repeat for the other feet.
2. After lowering the feet, check the rack to ensure it is stable and level.
3. Adjust the feet as necessary to ensure the rack is stable and level.
HP StorageWorks 4x00/6x00/8x00 Enterprise Virtual Array user guide
Figure 36).
CXO7589A
2. Leveler foot
99