Installing The Hp Netserver In An Hp Rack System/E Or Rack System/U; Introduction; Hp Netserver And Rack Components - HP LC2000r - NetServer - 128 MB RAM Installation Manual

8 Installing the HP NetServer in an HP
Rack System/E or Rack System/U

Introduction

This chapter describes how to mount the HP NetServer in an HP Rack System/E
or Rack System/U rack. If you have an older HP System rack, see Chapter 13,
"Alternative Rack Mounting," for instructions. (If you are mounting the HP
NetServer in a non-HP rack, refer to the separate rack-mounting guide for
third-party racks. It is packed in the accessories tray in the HP NetServer's
shipping box.)

HP NetServer and Rack Components

The HP NetServer LH 6000r requires eight EIA units of space.
Slide
Leveler
Foot
Inside Face
Bar
Nuts
Rack
Anti-Tip
Template
Foot
Figure 8-1. Installation Hardware
Outside
Face
Handles
Bezel
NetServer
Latch
Slide
Bezel
Member
Hinge
Bezel
79