Table of Contents
Advertisement
Chapter 7: Configuring VLANs on the SSR
b. Click the Add button.
Configuration Expert moves the selected port from the Available Port list to the
corresponding module in the Selected Port list.
If you accidentally add a port that you do not want to include in the VLAN, you
may remove it by double-clicking that port's module in the Selected Port list. From
the list of ports that appears, select the port you do not want in the VLAN. Then
click the Remove button.
10. Continue selecting ports and clicking the Add button until you have added all the
ports you want the VLAN to include.
Clicking a module rather than double-clicking it in a list box selects all of the module's
ports in that list box. This is a quick way to select all of a module's ports if you want to
add or remove them all at the same time.
11. Click Finish.
Configuration Expert adds the new VLAN to the VLANs found in the Protocol Based
VLANs object.
Creating a Port-Based VLAN
To create a VLAN that the SSR will use for IP, IPX, and bridged-protocol traffic:
1.
Start Configuration Expert if you have not already done so.
Note:
2.
Open the configuration file you want to modify and then double-click that file's
Bridging Configuration object.
3.
Double-click the VLAN Configuration object.
4.
Click the Configure New VLAN object.
Configuration Expert opens the VLAN wizard.
96
If you start Configuration Expert from the Schematic view choosing the
Configure VLAN command, Configuration Expert automatically expands
the Active Configuration file's tree to the VLAN Configuration object. If you
are adding a VLAN to the Active Configuration file, go to
step
3.
CoreWatch User's Manual
Advertisement
Table of Contents
