Table of Contents
Advertisement
Configuring IP Route Filters
The SSR uses IP route filters to match a certain set of routes by destination or by
destination and mask.
Note:
A route will match the most specific filter that applies. Specifying more than one
filter with the same destination, mask, and modifiers will generate an error.
To create IP route filters:
1.
Start Configuration Expert if you have not already done so.
2.
Open the configuration file you want to modify and then double-click that file's
Routing Configuration object.
3.
Double-click the IP Routing Configuration object.
4.
Double-click the IP Unicast Routing object.
5.
Double-click the Routing Policy Configuration object.
6.
Double-click the Building Blocks object.
7.
Double-click the Filters object, and click the Configure New Filter object.
Configuration Expert opens the Route Filter wizard.
8.
Click Next.
A Filter Name panel similar to the following appears:
CoreWatch User's Manual
Chapter 16: Configuring Routing Policies on the SSR
Figure 213. Filter Name panel
331
Advertisement
Table of Contents
