Table of Contents
Advertisement
Chapter 6: Configuring SSR Bridging
5.
From the Module drop-down list, select the module containing the port you want to
configure.
6.
From the Port drop-down list, select the port you want to configure.
7.
In the Timeout box, enter the number of seconds that the SSR is to allow a learned
MAC address to remain in the Layer-2 lookup table for the specified port.
You can specify from 15 to 1,000,000 seconds. The default is 300 seconds.
8.
Click OK.
Disabling Aging on a Port
Disable aging on a port if you do not want the SSR to age MAC address entries in the
port's Layer-2 lookup tables.
Disabling aging on a port may eventually cause the port's Layer-2 lookup tables
Caution:
to become full because the SSR will not remove MAC addresses from those tables.
To disable aging on a port:
1.
Start Configuration Expert if you have not already done so.
2.
Open the configuration file you want to modify and then double-click that file's
Bridging Configuration object.
3.
Double-click the Aging Configuration object.
72
Figure 27. Set Aging Timeout dialog box
CoreWatch User's Manual
Advertisement
Table of Contents
