Table of Contents
Advertisement
Configuring Layer-2 Address Filters
If you want to control access to a source or destination on a per-MAC address basis, you
can configure address filters. Address filters are always configured and applied to the
input port. You can set address filters on the following:
•
A source MAC address, which filters out any frame coming from a specific source
MAC address.
•
A destination MAC address, which filters out any frame destined to a specific
destination MAC address.
•
A flow, which filters out any frame coming from a specific source MAC address that is
also destined to a specific destination MAC address.
To configure address filters:
1.
Start Configuration Expert if you have not already done so.
2.
Open the configuration file you want to modify and then double-click that file's
Security Configuration object.
3.
Double-click the L2 Security object.
4.
Click the Configure New L2 Security Profile object.
Configuration Expert opens the L2 Security wizard.
5.
Click Next.
CoreWatch User's Manual
Figure 145. L2 Security wizard (address filter)
Chapter 13: Configuring Security on the SSR
229
Advertisement
Table of Contents
